How to read a battery comparison
Most battery comparisons are spec sheets. The specs matter, but they are not usually what separates two quotes sitting on your kitchen table. These four rows are:
- Usable capacity, not nominal. Manufacturers quote both, and the gap can be a kilowatt-hour or more. Usable is what you get, and it is also what the federal discount is calculated on, so it counts twice.
- What you have to buy alongside it. A battery with no inverter needs one. A battery with an inverter built in is wasted money if you already own a good one. This is the biggest single swing in the final price, and it is why the same battery can be right for your neighbour and wrong for you.
- What backup actually includes. Most systems need extra hardware before anything stays on in a blackout, and "backup ready" in a quote often means the wiring is there and the equipment is not. Whole-home and selected-circuit backup are different products at different prices.
- Warranty retention. Ten years is nearly universal, so it tells you little. The percentage of capacity still guaranteed at the end of those ten years is not universal: it ranges from 60% to 70% among the systems here. On a 16kWh battery that difference is about 1.6kWh of allowed fade.
What this comparison does not tell you
It cannot see your roof, your switchboard, your meter or your usage pattern, and those decide a real price. It also has no installation-quality dimension, because we have no defensible way to measure that and inventing one would be worse than leaving it out. Use this to narrow a field to two or three, then have someone look at your actual home.
Common questions
Why are your prices different from other comparison tables?
Because ours are installed prices and most are not. The best-known Australian battery comparison lists hardware at retail excluding installation, which it puts at roughly $3,000 extra. We show an indicative installed figure after the federal discount, and each one states exactly what it covers. They are our estimates from public sources, not quotes and not job data.
What does "estimate" mean on a figure?
Every fact here carries one of three labels. Confirmed means we read it in a manufacturer datasheet, warranty document or regulator notice and linked it. Estimate means it is our figure derived from several public sources, which is always the case for installed prices. Not established means we could not verify it, and we would rather show the gap than fill it.
Does a cheaper battery here mean a cheaper system?
Not necessarily, which is why the comparison shows what you have to buy alongside the battery. A system with no inverter included, or one where backup needs a separate gateway or switch box, can finish dearer than a higher headline price that includes both. The "What you have to buy" and "Blackout backup" sections exist to stop a cheap headline hiding a different system.
Can I compare a battery against a quote I already have?
Yes. Pick the system you have been quoted, check the configuration your quote describes against the rows here, and pay particular attention to usable capacity, what the backup arrangement includes, and the warranty retention percentage. Those three are where comparable-looking quotes most often differ.
Keep going
- Find my battery: answer six questions and get a shortlist with the reasoning shown.
- Check my quote: send us a quote you already have and a person will read it.
- The full catalogue: every system we hold a record for, with filters.
- Solar battery cost: what households actually pay, by size.
- Battery and inverter compatibility: what works with the solar you already have.